Ceramic particles are a very common pavement material in daily life. It is made of hard materials and high-temperature firing. It is very firm on the pavement, will not easily break, and has a long service life. The following describes the firing of ceramic particles temperature
A.The temperature of the particles is too low, the material is "upripe", the color is slightly bright, the hardness of the Mohs is not up to the standard, and it is easy to wear.
B. If the temperature is too high, the material looks too "old", if the situation is serious, it will cause the color imbalance, and the fuel cost is still high.
C.When choosing ceramic particles, we try not to use "uprise" in large quantities. Even if the cost is a little lower, do not use them on the road in large quantities. Do not pick up sesame seeds and lose watermelon because of small losses.
D.After the semi-finished products are put into the kiln, it is a process of preheating to heating and then cooling. Each step requires sufficient time and temperature control. Too high or too low temperature will not work, strictly control the temperature.
E.When the porcelain stone is taken in the mining area, it must be broken by hand with a hammer, and the shape is as large as an egg, and then it is pounded into a powder with a water dipper, washed, and impurities are removed. After precipitation, it is made into a brick. Like mud.
F. Reconcile the mud with water at a suitable temperature to remove the slag. It is also possible to continuously rub with both hands or step on it with your feet to squeeze out the air in the mud and make the moisture in the mud even. The product has been produced.
The firing temperature of ceramic particles is very high. Please pay attention to safety when firing, do not touch, avoid burning your own skin, and do not choose large quantities of used "raw" when choosing particles, although the cost is low, But the risk factor is high.
